Front-Panel Operation
Introduction 3
3-3
Introduction
The Calibrator can be controlled either by sending commands through one of its
communication interfaces or by manual manipulation of its front-panel controls. This
chapter explains the function and use of the controls and indicators located on the front
and rear panel, of the Calibrator. This chapter is meant to be of an overview of the
Calibrator. Detailed information on using the Calibrator is found in Chapter 4,
“Calibrating Instruments”. Chapter 5 covers operating the Calibrator through its remote
communication interfaces.
Controls and Indicators
The following sections describe the various controls, indicators, and connectors used to
interface and source signals to a Unit Under Test (UUT).
Front-Panel Feature Descriptions
Table 3-1 lists the controls and connectors found on the front panel.
XWWarning
To avoid electric shock, use only high-quality, shrouded test
leads with the appropriate CAT and voltage rating to connect
instruments to the Calibrator.
To Next Page
Loading...
Need help?
General
