To Next Page

To Previous Page

5-1

Chapter 5

Remote Operation

Title Page

Introduction........................................................................................................ 5-3

Using the IEEE 488 Port for Remote Control ................................................... 5-3

IEEE488 Bus Restrictions............................................................................. 5-3

Setting up the IEEE 488 Port......................................................................... 5-3

Using the RS-232 Port for Remote Control....................................................... 5-4

Setting up the RS-232 Port............................................................................ 5-4

RS-232 Connector Pinout.............................................................................. 5-5

Exceptions for RS-232 Remote Control........................................................ 5-5

Using the Ethernet Connection for Remote Control.......................................... 5-5

Factory Settings ................................................................................................. 5-6

Command Syntax Information........................................................................... 5-6

Parameter Syntax Rules................................................................................. 5-6

Terminators.................................................................................................... 5-7

Numeric Output Format ................................................................................ 5-7

Supported SCPI Commands .............................................................................. 5-7

Description of Abbreviations ........................................................................ 5-8

SCPI Command Summary ............................................................................ 5-8

SCPI Command Details................................................................................. 5-17

Using the OUTPut Commands.................................................................. 5-17

Using the SOURce Commands................................................................. 5-17

Using SYSTem Commands ...................................................................... 5-39

Using the STATus Subsystem .................................................................. 5-40

Using IEEE 488.2 Common Commands................................................... 5-41

Standard Status Data Structures .................................................................... 5-43

SRE Service Request Enable Register ...................................................... 5-45

ESR Event Status Register........................................................................ 5-45

ESE Event Status Enable Register ............................................................ 5-46

IEEE 488 Interface Configuration................................................................. 5-47

Fluke 5320A User Manual

Other manuals for Fluke 5320A