Front-Panel Operation
Factory Settings 3
3-15
Factory Settings
Table 3-4 lists the setup functions and their respective factory set values.
Table 3-4. Factory Settings
Setup Item Factory Set Value
Volume 15
Brightness 6
Beeper ON
Calibration password 0
Time GMT
Date GMT
Voltage calibrator Yes/No
Compensator Yes/No
Calibrator GND ON
High resistance source GND ON
R multiplier input 0 MN
Low resistance source GND ON
Loop impedance correction OFF
Loop impedance MAN value 0.000 N
Loop impedance SCAN value 0.000 N
Line impedance correction OFF
Line impedance MAN value 0.000 N
Line impedance SCAN value 0.000 N
Substitute LC Rout 2.000 N
RCD I level 90 %
RCD serial resistance R0
Meter GND OFF
Error Messages
Error messages appear in the Calibrator’s display when either an invalid operation is
attempted or some internal check reveals a problem with the Calibrator. Some conditions
that generate error messages are:
• Invalid front-panel operations that try to force a prohibited mode, such as setting an
out-of-range value.
• Internal faults such as a communications error between functional parts of the
Calibrator.
• Invalid commands to the communications interface.
To Next Page
Loading...
Need help?
General
