5320A
Users Manual
1-6
Safety Information
XWWarning:
To avoid electric shock, personal injury, fire, or death, observe the following warnings
before using the Calibrator:
• Use the Calibrator only as specified in this manual, or the protection provided by the
instrument might be impaired.
• Do not use the Calibrator in wet environments.
• Inspect the Calibrator before using it. Do not use the Calibrator if it appears damaged.
• Do not use the Calibrator if it operates abnormally. Protection may be impaired. If in
doubt, have the Calibrator serviced.
• Have the Calibrator serviced only by qualified service personnel.
• Always use the power cord and connector appropriate for the voltage and outlet of the
country or location in which you are working.
• Connect the Calibrator power cord to a power receptacle with an earth ground. A
protective ground connection by way of the grounding conductor in the power cord is
essential for safe operation.
• Never remove the cover or open the case.
• Never operate the Calibrator with the cover removed or the case open.
• Use caution when working with voltages above 30 V ac rms, 42 V ac peak, or 60 V dc.
These voltages pose a shock hazard.
• Use only the replacement fuse(s) specified by the manual.
• When servicing the Calibrator, use only specified replacement parts.
XWWarning
To prevent personal injury, use good lifting practices when lifting or moving the Calibrator.
The Calibrator is an unbalanced load and weighs in excess of 18 kg (40 pounds).
Avoiding Instrument Damage
WCaution
To avoid damage to the Calibrator, read the following cautions
before using:
• To prevent damage to the Calibrator, do not use aromatic
hydrocarbons or chlorinated solvents for cleaning.
To Next Page
Loading...
Need help?
General
