FP PostBase Fusion - Standby Time; Product after Standby

Advanced settings & system information
115
14.8 Standby time
The PostBase Fusion mailing system will go to standby automatically if it is not used
for some time. The standby time is the time between your last operation and the time
PostBase Fusion automatically goes to standby.
• Open the M
ENU.
• Choose S
TANDBY SETTINGS.
• Choose S
TANDBY TIME.
PostBase Fusion opens the standby time
setting menu.
• Type the desired time (in minutes).
• Confirm with OK.
14.9 Product after standby
This feature lets you define which product will be set for metering after reactivating
PostBase Fusion from standby:
– the product stored as the first shortcut or
– the product that was last used.
• Open the M
ENU.
• Choose S
TANDBY SETTINGS.
• Choose R
ATE AFTER STANDBY.
PostBase Fusion opens the setting menu for
this function.
• Tap the desired setting.
• Apply the displayed setting by tapping OK.
RATE AFTER STANDBY – possible settings and their meaning:
S
HORTCUT 1 After reactivating PostBase Fusion from
standby, the product stored as first shortcut is
set.