Installation and commissioning
33
Step 7: Installing the PostBase Fusion Feeder (optional)
Caution! Only connect the Feeder once the
PostBase Fusion postage meter is fully
installed. Otherwise the PostBase Fusion will
not recognize the feeder. The mailing system
will not work.
Turning off the postage meter
• Press the ON/OFF button for three sec-
onds.
The PostBase Fusion will complete any cur-
rent actions, return the display to its home
position, and then turn itself off.
Setting up the feeder
• Place the ramp, feeder and postage meter
as shown in the illustration above.
• When assembling, ideally proceed from
left to right (starting at the ramp).
The components are mechanically coupled
3 seconds
Ramp
Feeder
PostBase Fusion
postage meter
To Next Page
Loading...
