FP PostBase Fusion - Changing the Ink Cartridges

PostBase Fusion
134
15.6 Changing the ink cartridges
PostBase Fusion monitors the ink level of the cartridges and issues a message when
it must be replaced. We recommend that you always have a new ink cartridge in
stock.
We advice to clean the contacts in the cartridge bracket at each cartridge replace-
ment. Use the special “clean & renew” cleaning kit for PostBase Fusion, available
from FP.
Caution! The ink contains small quantities of components that are hazardous
to health and may cause eye, skin and respiratory irritation and allergic reac-
tions. Ink may be harmful if swallowed.
• Avoid eye and skin contact with the ink.
• Avoid inhaling ink fumes.
• Avoid swallowing the ink.
• Keep out of reach of children.
Caution! Note the following hints to avoid damage to the print system:
• Do not attempt to manually open the ink cartridge flap (cover) of the
machine. To open, go to the M
ENU on the PostBase Fusion and then
select I
NK CARTRIDGE and CHANGE CARTRIDGE and the flap will
automatically open.
• We recommend to use only approved FP equipment and FP original parts.
The manufacturer FP has established reliability, safety and applicability.
The manufacturer cannot assess the reliability, safety and applicability for
products not approved by FP, and therefore not vouch for such products.
• Always use brand new ink cartridges.
• The clip attached to some ink cartridges as transportation protection is
intended for single use only. Ideally dispose of the clip immediately. Never
put the clip back on the cartridge in order to prevent damage to the print
nozzle plate, which can cause short circuits, overheating and melting of
components.