FP PostBase Fusion - Imprint Offset

PostBase Fusion
64
5.4 Imprint offset
PostBase Fusion prints the meter imprint at a
fixed offset from the right mail piece edge.
You can increase this offset and thus shift the
meter imprint to the left by adjusting the
imprint offset.
If an imprint offset is set, it appears together
with an icon in the Home screen.
Setting an imprint offset
• Open the M
ENU.
• Choose I
MPRINT OFFSET.
PostBase Fusion opens the setting menu for
the imprint offset.
• Type the desired amount for the offset.
• Confirm the displayed imprint offset with
OK.
The imprint offset for the meter imprint is set
and remains effective until the next change –
even after the unit is turned off.
The info panel in the Home screen shows the
set imprint offset.
Set imprint offset