PostBase Fusion
92
9.4 Seal Only (PostBase Fusion with feeder)
With the special function “Seal Only”, you can seal and count letters without printing
(up to 0.3" / 7 mm). This special function is only available on PostBase Fusion sys-
tems with feeder. Please refer to the mail piece specifications on pages 186 to 187.
• On the feeder, switch on the seal function:
Set the switch to the position seal (see also
chapter 6.3.3.2, page 75).
• Open the M
ENU.
• Choose S
PECIAL FUNCTIONS.
• Choose S
EAL ONLY.
PostBase Fusion opens the “Automatic
Feeding” pop-up for the “Seal Only” function.
All settings for automatic feeding, preparing
and positioning letter stacks are done exactly
as when metering mail. For detailed informa-
tion, please read chapter 6.3.3.
• Position letter stack on the feeder / start
letter transport.
The “Seal Only” function has its own counter.
PostBase Fusion shows the number of trans-
ported mail pieces on the upper right side of
the display.
When leaving the “Seal Only” function, the
counter is reset to “0”.
Counter
To Next Page
Loading...
