PostBase Fusion
120
14.13 Network connection (Connectivity settings)
To exchange data with FP servers (postage download, customer portal, updating
rates and software, etc.) PostBase Fusion must be able to connect to the Internet.
During setup and installation, setting up the network connection is part of the instal-
lation procedure. You must check the settings after making changes to your equip-
ment / your system environment and adjust them as needed. If you have any
questions, please contact your administrator.
You can set up one wired
connection (Ethernet / LAN) as well as one Wi-Fi connec-
tion. Each time PostBase Fusion is turned on, it checks availability and enables the
corresponding network connection (LAN or Wi-Fi), whereas any wired connection will
always be given priority. You can recognize the enabled connection by the icon in the
menu bar (see page 45).
14.13.1 Displaying connectivity settings
• Open the MENU.
• Choose M
ANAGE CONNECTION.
PostBase Fusion displays the saved connec-
tivity settings and the corresponding status
information.
At the end of the list, you can tap on to
open an overview with advanced information
(routing information).
14.13.2 Setting up a new network connection / changing settings
• Open the MENU.
• Choose M
ANAGE CONNECTION.
• Tap C
HANGE to open the procedure for set-
ting up the network connection.
• First, select which type of connection you
would like to set up or change:
Tap either E
THERNET / LAN WI-FI.
• Confirm the selection and continue with the
C
ONTINUE button.
To Next Page
