PostBase Fusion
74
6.3.3 Feeder (optional)
Equipped with the feeder, PostBase Fusion can feed letters and postcards from a
stack and process them. Please refer to the mail piece specifications and the enve-
lope specifications for automatic sealing on pages 186 to 187.
6.3.3.1 Preparing letter stacks and setting up feeder
Caution! Potential danger due to automatic start-up.
When the PostBase Fusion is ready for metering, the letter transport starts
up as soon as an object covers the sensor for letter detection. For this reason,
do not place your hand anywhere near the sensor. Do not allow any objects
to reach the sensor area. This way, you can avoid accidentally starting the
letter transport.
To set up the feeder, you can open the M
ENU. PostBase Fusion is not ready
for metering at this time and the letter transport cannot start.
Preparing letter stacks
• Sort letter stacks so that all envelope flaps
are facing downward.
• Align top edges flush: Position the letter
stack with the letter top edges on a level
surface, loosen up and jog to align.
Adjusting the letter guide
• Place a stack of letters:
– Side to be printed (address side)
facing up.
– The letter top edges are on the contact
area.
– Do not exceed permissible stack height
(2.2" / 55 mm).
• Adjust the letter guide so that it is flush with
the letter stack.
Contact area
To Next Page
Loading...
