FP PostBase Fusion - Cleaning the Print System; Starting Automatic Print System Cleaning; Intensive Cleaning

Maintenance and care
129
15.3 Cleaning the print system
15.3.1 Starting automatic print system cleaning
You should start automatic print system cleaning only if the quality of the imprint is
not good enough (e.g. blank spots in the imprint after longer periods out of use).
Cleaning
• Open the M
ENU.
• Choose I
NK CARTRIDGE.
• Choose C
LEANING.
A message informs you about the cleaning
process in progress.
• Confirm the message with OK.
• Check the quality of the imprint with a Test
Imprint (see chapter 15.4).
Intensive cleaning
You should start intensive cleaning if normal
cleaning fails to improve the print quality to
your satisfaction.
• Open the M
ENU.
• Choose I
NK CARTRIDGE.
• Choose I
NTENSIVE CLEANING.
A message informs you about the cleaning
process in progress.
• Confirm the message with OK.
• Check the quality of the imprint with a Test
Imprint (see chapter 15.4).
In case of stubborn soiling, even intensive
cleaning may be unable to improve the print
quality as desired. In such cases, you can
manually clean the cartridge. Read the follow-
ing chapter.