Maintenance and care
139
• Unlock the drawer: Push the drawer latch
lever upwards.
• Pull the drawer to the front, out of the
housing.
• Place the drawer on an underlay.
The flashing LEDs in the letter entrance area
indicate the drawer is missing.
Remove worn-out transport brush
The transport brush is held in the brush
carrier by two catches on the right side.
• Grab the bristles, pull the worn-out
transport brush to the left to unlock it and
pull it upwards out of the brush carrier.
Insert new transport brush
• Insert the new transport brush into the
brush carrier like shown in the illustration
(1).
• Push down the brush on the right side until
it locks into place beneath the two catches
(2).
Catches
Spline
Cut-out
To Next Page
