PostBase Fusion
148
• Lift the basket with the sponge out of the
tray.
• Clean sponge or replace with a new one.
• Put a new sponge (with basket / sponge
holder) into sealing fluid before inserting it,
and let it soak completely. The flaps are
thus correctly moistened from the first letter
on.
• Carefully insert the basket with sponge into
the tray until basket and tray are flush.
Mind the position of the cut-out.
• Check if the basket is correctly seated:
It must rest on the extreme left in the tray
and close on top in a flushed manner.
• Insert the complete tray into the housing
until it clicks into place.
• Check if the sponge is correctly seated. It
should be directly below the moistening felt
and brush.
Basket / sponge holder
Sponge
Cut-out
Check:
Basket on the
extreme left
Basket flushed on top
To Next Page
Loading...
