For your safety
9
Accessories and consumables
• We recommend to use only approved FP equipment and FP original parts.
The manufacturer FP has established reliability, safety and applicability.
The manufacturer cannot assess the reliability, safety and applicability for products
not approved by FP, and therefore not vouch for such products.
Full functionality of the PostBase Fusion mailing system is only guaranteed at the
time of delivery if genuine FP ink cartridges are used.
• Use the supplied power and connection cables or cables that have been approved
by FP. Make sure that the cables are not damaged.
• When handling ink cartridges, observe the product information enclosed with each
package. Avoid eye and skin contact with the ink. Avoid inhaling ink fumes. Make
sure that ink cartridges do not get into the hands of children. Ingestion of the ink
can be harmful to health. Detailed information can be found on the Material Safety
Data Sheet (MSDS), available at sdb.francotyp.com/en.
• The ink cartridge may be equipped with a clip as transportation protection, depending
on the model. Remove the clip before inserting the cartridge. Dispose of the clip.
Never put the clip back on the cartridge in order to prevent damage to the print
nozzle plate, which can cause short circuits, overheating and melting of components.
General safety instructions
• Set up and install the PostBase Fusion mailing system as described in the
“Installation and commissioning” section.
• Never transport the PostBase Fusion mailing system by attachments such as weigh-
ing platform, label compartment, display or drawer. The best way to transport the indi-
vidual components is to hold them on the side at the bottom in the recesses on the
housing.
• If the mailing system was previously in a cold environment (i.e. below 50 °F / 10 °C):
Unpack the mailing system and wait at least two hours before setup and installation
of the PostBase Fusion mailing system. The PostBase Fusion needs this time to
adapt to the environmental conditions allowing any condensed moisture to escape.
• The “PostBase Fusion Feeder” is designed for operation on the PostBase Fusion
postage meter. The Feeder cannot be operated without being connected to the
PostBase Fusion postage meter base.
• If the mailing system develops strong odors, fumes or unusual noises, immediately
unplug the power plugs from the outlets.
• Only have maintenance and repair work carried out by qualified personnel
approved by FP. Otherwise any warranty claims may become void.
• Note: When a letter is fed, letter transport will start automatically after a short delay.
To Next Page
Loading...
