PostBase One Franking System
14
Disconnecting the PostBase One from
mains
Caution! Make sure to always turn the
PostBase One off by pressing the rocker
switch for three seconds before disconnect-
ing the PostBase One from mains. Never pull
the power plug or separate the power supply
in any other way before the printing system
has reached its sealed position. This is the
only way to prevent drying up and to ensure
a permanently high print quality.
• Press the rocker switch for three seconds
to turn the franking system off.
• Unplug the power cable from the socket.
3.2 Standby
The PostBase One franking system will go to
standby automatically if it is not used for
some time.
The display is dark in standby.
You can ‘wake up’ PostBase One by briefly
touching the display. Alternatively, you can
briefly press the rocker switch.
To Next Page
Loading...
