Fuji Electric FRENIC MEGA G2 Series - Page 100

3.3 Running Mode
3-16
3.3.9 Changing the M/Shift key function
When in Running mode, various functions can be assigned to the M/Shift key in the same way as digital input
terminals based on the function code E70 setting. The switching between remote and local modes described in the
previous section is one of these functions.
The factory default setting is 100 (no functions).
 Refer to the description of function code E70 in Chapter 5 “5.3.2 E codes (terminal functions)” for details.
3.3.10 Display when keypad operation disabled (command source display)
When the / key or / key is pressed in running mode (monitor item display), the command source is
displayed for 2 seconds if these operations are disabled.
However, in such cases as where keypad key information reading is enabled with customizable logic, the command
source will not display if the / key or / key is being used for another function.
Table 3.3-8 Display when run/stop operation is disabled with / key
Displayed
content
Reason for operation being disabled
Displayed
content
Reason for operation being disabled
di
Terminal block input
buS
Bus option input
rS.Ch2
RS-485 port 2 input
Ldr
FRENIC Loader input
Table 3.3-9 Display when frequency change operation disabled with / key
Displayed
content
Reason for operation being disabled
Displayed
content
Reason for operation being disabled
Ai.12
Voltage input (terminal [12])
PuLSE
Pulse train input
Ai.C1
Current input (terminal [C1])
rS.Ch2
RS-485 port 2 input
12-C1
Voltage + current input (terminal
[12] + [C1])
buS
Bus option input
Ai.U2
Voltage input (terminal [V2])
Ldr
FRENIC Loader input
Ai.U3
Voltage input (terminal [V3])
MuLti
Multistep frequency input
uP-dn
UP/DOWN (terminal [X1 X9])
Pid
PID control input
Ptn
Pattern operation
nonE
No command source
di
OPC-DI (option) input
Displays for 2 seconds
By pressing the / key during multistep
frequency operation, “
Multi
”, meaning
multistep frequency input, displays for 2
seconds.
Display example in which / operation is disabled