Fuji Electric FRENIC MEGA G2 Series - Page 106

3.4 Programming Mode
3-22
Table 3.4-2 “Drive Monitoring” display items (cont.)
Monitor
No.
Symbol
Item
Unit
Description
3_14
ratio
Ratio setting
%
When this setting is 100%, the LED monitor
shows 1.00 time of the value to be
displayed.
If no ratio setting is selected, “-----”
appears.
3_15
line
Feed speed
m/min
(Output frequency Hz) ×
Function code E50
Function code E39
3_16
LSC
Peripheral speed
m/min
The constant surface speed control winding
speed is displayed.
3_17
e
Stop target position
N/A
Refer to Chapter 5 “5.3.9 [ 5 ] Position
control.”
3_18
p
Current position
N/A
3_19
dp
Position deviation
N/A
3_20
po5.md
Position control status
monitor
N/A
3_21
mU
PID output value
%
Displays the PID output value. (100% at
maximum frequency)
If PID control is disabled, “-----” appears.
3_22
flUx
Flux command value
%
Magnetic flux command value.
3_23
Stat2
Running status 2
N/A
Refer to “
Displaying running status (3_07) and
running status 2 (3_23)” for details.
3_24
ntc
Motor temperature
°C
Temperature detected with NTC thermistor
built in to the motor (VG motor)
“-----” appears if no NTC thermistor
connection has been set.
3_25
sy-d
Master-follower operation
deviation
deg
Displays the current angle deviation. Refer
to Chapter 5 “5.3.9 [ 2 ] Master-follower
operation.”
3_29
pG-fb
PG feedback value
Hz
Displays the frequency detected by the PG
in Hz regardless of the control method.
3_32
trq.b
Torque bias command
%
Displays the selected torque bias command
value.
3_34
dt-ld
Load detection monitor
Displays momentary detected loads.
Refer to Chapter 5 “5.3.9 d codes (Applied
functions 2) [ 4 ] Hoist function” for details.
3_35
Lin-i
Constant surface speed
control line speed setting
value
m/min
Displays the [Motor setting speed × winding
diameter ratio].
3_36
Lin-o
Constant surface speed
control line speed output
m/min
Displays the [Motor output speed × winding
diameter ratio].
3_50
p-ref
Command (master) side
AB-phase pulse rate
kp/s
Displays the pulse rate input to the PG AB-
phase used as the command (master) side.
3_51
Z-ref
Command (master) side Z-
phase pulse rate
p/s
Displays the pulse rate input to the PG Z-
phase used as the command (master) side.
3_52
p-fb
Feedback (follower) side
AB-phase pulse rate
kp/s
Displays the pulse rate input to the PG AB-
phase used as the feedback (follower) side.
3_53
Z-fb
Feedback (follower) side
Z-phase pulse rate
p/s
Displays the pulse rate input to the PG Z-
phase used as the feedback (follower) side.