Fuji Electric FRENIC MEGA G2 Series - Page 233

5.2 Function Code Tables
5-49
FUNCTION CODES
Chap 5
Function
code
Name
Control method and Data setting range
Change when running
Data copying
Factory
default
Related page
y98
Bus function
(Operation selection)
Frequency setting/torque command Run command
0: Based on H30 Based on H30
1: Bus link Based on H30
2: Based on H30 Command from bus
3: Command from bus Command from bus
Y
Y
0
5-420
y99
Support link function
(Operation selection)
Frequency setting Run command
0: Based on H30, y98 Based on H30, y98
1: Commands from FRENIC Loader Based on H30, y98
2: Based on H30, y98 Commands from FRENIC
Loader
3: Commands from FRENIC Loader Commands from FRENIC
Loader
Y
N
0
5-420