Chapter 5
FUNCTION CODES
This chapter explains the table of function codes used in FRENIC-MEGA, index per purpose, and the detail of each
function code.
Contents
5.1 Function Codes Overview ························································································ 5-1
5.2 Function Code Tables ····························································································· 5-2
5.2.1 Supplementary note ························································································ 5-2
5.2.2 Function code tables ······················································································· 5-4
[ 1 ] F codes: Fundamental functions ········································································ 5-4
[ 2 ] E codes: Extension Terminal Functions (terminal functions) ····································· 5-8
[ 3 ] C codes: Control Functions of Frequency (Control function) ··································· 5-16
[ 4 ] P codes: Motor 1 Parameters (Motor 1 parameters) ·············································· 5-18
[ 5 ] H codes: High Performance Functions (High level functions) ·································· 5-20
[ 6 ] A codes: Motor 2 Parameters (Motor 2 parameters) ·············································· 5-26
[ 7 ] b codes: Motor 3 Parameters (Motor 3 parameters) ·············································· 5-29
[ 8 ] r codes: Motor 4 Parameters (Motor 4 parameters) ··············································· 5-31
[ 9 ] J codes: Application Functions 1 (Application function 1) ········································ 5-33
[ 10 ] d codes: Application Functions 2 (Application functions 2) ······································ 5-36
[ 11 ] U codes: Application Functions 3 (Customizable logic) ·········································· 5-43
[ 12 ] y codes: LINK Functions (Link functions) ···························································· 5-48
[ 13 ] o codes: Option Functions (Option functions) ······················································ 5-50
[ 14 ] K codes: Keypad functions (Keypad functions) ···················································· 5-53
5.3 Description of Function Codes ················································································· 5-66
5.3.1 F codes (Fundamental functions) ······································································ 5-66
[ 1 ] Setting the frequency with the keypad (F01 = 0 (factory default) or 8) ······················· 5-68
[ 2 ] Setting the frequency with analog input (F01 = 1 to 3, 5, 6) ····································· 5-69
[ 3 ] Frequency setting by digital input signal “UP”/“DOWN” (F01=7) ······························· 5-76
[ 4 ] Frequency setting using digital input (option DIO interface card) (F01 = 11) ··············· 5-77
[ 5 ] Frequency setting using pulse train input (F01 = 12) ············································· 5-78
5.3.2 E codes (Extension terminal functions) ···························································· 5-136
5.3.3 C codes (Control functions) ··········································································· 5-190
5.3.4 P codes (Motor 1 parameters) ········································································ 5-201
5.3.5 H codes (High performance functions) ····························································· 5-212
[ 1 ] Measuring the capacitance of DC link bus capacitor in comparison
with initial one at shipment ············································································ 5-233
To Next Page
Loading...
