Fuji Electric FRENIC MEGA G2 Series - Page 26

1.1 Acceptance Inspection (Nameplate and Inverter Type)
1-2
There are two specifications of inverter, HHD and HND, and the specification is changed based on the load applied
to the inverter.
The respective specification is indicated on the nameplate.

For details on the HHD and HND specifications, refer to Chapter 4 “4.4 Switching the Applicable Motor Rating
(HHD/HND Specifications)” and Chapter 10 “10.4 Selecting the Inverter Rating Specification (HHD/HND)” in
this manual.
Furthermore, the rated current differs for the HHD and HND specifications, and the diameter of the wiring and
the applicable instruments and devices will therefore differ.

Refer to Chapter 2 “2.2 Wiring” in this manual for details on the applicable wiring.

Refer to Chapter 11 “11.3 Molded Case Circuit Breakers, Earth Leakage Circuit Breakers, and Magnetic
Contactors” in this manual for details on molded case circuit breakers, earth leakage circuit breakers, and
magnetic contactors. Refer to Chapter 11 in this manual for details on other applicable instruments and devices.
HHD:
Specification for heavy duty applications, overload current rating: 1 min at 150% of rated output
current, 3 s at 200%
HND:
Specification for normal applications, overload current rating: 1 min at 120% of rated output current
SOURCE:
Number of input phases (three-phase: 3PH), input voltage, input frequency, input current
OUTPUT:
Number of output phases, rated output voltage, output frequency range, rated output current, and
overload capacity
MOTOR:
Applicable motor
IE2/LOSS:
ErP (Energy related products) directive indication (grade/loss (%))
Loss data that occurs under all operating conditions can be referenced from a QR code.
MFG
ErP (Energy related products) directive indication (year of manufacture (western calendar))
IP CODE
Protection level
SCCR:
Short-circuit capacity
MASS:
Mass of the inverter in kilograms
SER. No.:
If you suspect the product is not working properly or if you have any questions about your product, contact your Fuji
Electric representative.
Product number 3 1 A 1 2 3 A 0 5 7 9 AA
Product version
Production year and week 6 0 1
Production week: The 1st week of January is indicated as
'01'. This indicates the week number that
is numbered from 1st week of January.
Production year: Last digit of year