Fuji Electric FRENIC MEGA G2 Series - Page 269

5.3 Description of Function Codes 5.3.1 F codes (Fundamental functions)
5-85
FUNCTION CODES
Chap 5
FUNCTION
CODES
F Codes
E Codes
C Codes
P Codes
H Codes
A Codes
b Codes
r Codes
J Codes
d Codes
U Codes
y Codes
K Codes
F07, F08
Acceleration time 1, Deceleration time 1
Related function codes:
E10, E12, E14 Acceleration time 2, 3, 4
E11, E13, E15 Deceleration time 2, 3, 4
H07 Curve acceleration/deceleration
H56 Deceleration time for forced stop
H54, H55 Acceleration/deceleration time (Jogging)
H57 to H60 Acceleration/deceleration range No. 1, No.2 S-curve range
E61 to E63, E66 Analog input (Extension function selection)
d86 Acceleration/deceleration time filter time constant
Acceleration time sets the time taken by the output frequency to reach the maximum output frequency from 0Hz,
and deceleration time sets the time taken by the output frequency to reach 0 Hz from the maximum frequency.
• Data setting range: 0.00 to 6000 (s)
V/f control
Speed sensorless vector control
Vector control with speed sensor
Acceleration time 1
Deceleration time 1
Maximum
output
frequency
(F07)
(F08)
Starting frequency 1
(F03)
(F23)
Stop frequency
Starting frequency 1
(F23)
(F25)
(F25)
(F03)
Stop frequency
(F08)
Acceleration time 1
Maximum
output
frequency
Deceleration time 1
Acceleration time 1
(F07)
Maximum
output
frequency
(F03)
Deceleration time 1
(F08)
Starting frequency 1
(F23)
Stop frequency
(F25)
Depends on the run
command
Actual
deceleration time
Actual
acceleration time
(F07)