Fuji Electric FRENIC MEGA G2 Series - Page 306

5.3 Description of Function Codes 5.3.1 F codes (Fundamental functions)
5-122
Under speed sensorless vector control/vector control with sensor (induction motors, permanent magnet
synchronous motors) (F42 = 5, 6, 15, 16)
If the inverter’s output torque exceeds the specified levels of the torque limiters, the inverter controls the speed
regulator’s output (torque command) in speed control or a torque command in torque control in order to limit the
motor-generating torque.
Related function code
Function
code
Name
Vector control
Remarks
F40
Torque limiter 1-1
Y
F41
Torque limiter 1-2
Y
E16
Torque limiter 2-1
Y
E17
Torque limiter 2-2
Y
H73
Torque limiter (0perating conditions selection)
Y
H74
Torque limiter (Control target)
Y
H75
Torque limit (Applicable quadrant)
Y
H76
Torque limiter (Frequency rising limit for
braking)
Y
E61 to E63,
E66
Terminal [12], [C1] (C1 function), [V2], [C1]
(V3 function), extension function selection
Y
7: Analog torque limiter A
8: Analog torque limiter B
 Torque limiter (Control target) (H74)
Under vector control, the inverter can limit motor-generating torque or output power, as well as a torque current
(default).
H74 data
Control target
0
Keeps torque constant.
1 (factory default)
Keeps torque current constant.
2
Keeps power constant.

󲎠󰕹
󲝢󰼗󲛩100 %󰪍

󲛩50 %󰪍

󲛩50 %󰪍

󰎤󰯢100 %
󰎤󰯢100 %
󰎤󰯢50 %
󰎤󰯢200 %
Torque pattern when the torque
curent limit is 100% rating
Torque pattern when the torque
curent limit is 50% rating
100% rating
50% rating
100% rating
200% rating
Speed
Torque
Torque pattern when the power
limit is 50% rating