Fuji Electric FRENIC MEGA G2 Series - Page 596

5.3 Description of Function Codes 5.3.11 U1 codes (Customizable logic operation)
5-412
Setting example 3: One-shot operation
The required operation is as follows: SW-FWD or SW-REV switch is short-circuited to start the operation and the
SW-STOP switch is short-circuited to stop the operation (equivalent to / keys and / key on keypad), if the
above operation is required, replace an external circuit that is conventionally needed with customizable the
customized logic.
To configure this customizable logic, set the function codes as follows. (Timer selection) and (Timer setting) do not
need to be modified if no change is made.
Function code
Setting
value
Setting
Remarks
F02
Operation method
1
External signal
E01
Terminal [X1] (Function selection)
100
No function assigned “NONE”
E98
Terminal [FWD] (Function selection)
100
No function assigned “NONE”
E99
Terminal [REV] (Function selection)
100
No function assigned “NONE”
U00
Customizable Logic (Mode selection)
1
Enable
U01
Customizable logic:
Step 1
(Block selection)
30
Logical OR + general-purpose
timer
Mode
selection
U02
(input 1)
4011
Terminal [REV] input signal
“REV”
U03
(input 2)
4001
Terminal [X1] input signal “X1”
U06
Customizable logic:
Step 2
(Block selection)
60
Reset priority flip-flop + general-
purpose timer
Mode
selection
U07
(input 1)
4010
Terminal [FWD] input signal
“FWD”
U08
(input 2)
2001
Output of step 1 “SO01”
U11
Customizable logic:
Step 3
(Block selection)
30
Logical OR + general-purpose
timer
Mode
selection
U12
(input 1)
4010
Terminal [FWD] input signal
“FWD”
U13
(input 2)
4001
Terminal [X1] input signal “X1”
U16
Customizable logic:
Step 4
(Block selection)
60
Reset priority flip-flop + general-
purpose timer
Mode
selection
U17
(input 1)
4011
Terminal [REV] input signal
“REV”
U18
(input 2)
2003
Output of step 3 “SO03”