5.3 Description of Function Codes 5.3.13 K codes (Keypad functions)
K53
K54 to
K65
K58 to
K65
Traceback CH4 operation selection
Traceback analog Ch1 to 4 source selection
Traceback digital Ch1 to 8 source selection
By selecting the analog input/output signal or digital input/output signal to be saved when an event occurs using
the FRENIC Loader4 inverter support software and setting it in the inverter, setting information is saved to this
function code.
Events are set to when “alarms” occur by factory default.
Traceback data display example
Refer to the Instruction Manual (INR-SI47-2104□) for the FRENIC-Loader4 inverter support software for details on
traceback.
To Next Page
Loading...
