Fuji Electric FRENIC MEGA G2 Series - 11.21 Control Terminal Block (G1 S Compatible) OPC-G1-TB1

11.21 Control Terminal Block (G1S Compatible) OPC-G1-TB1
11-85
SELECTING PERIPHERAL EQUIPMENT
Chap 11
11.21 Control Terminal Block (G1S Compatible) OPC-G1-TB1
The control terminal block for the conventional model MEGA (GS1) is available as an option to allow round crimp
terminals to be connected.
When using this terminal block option, terminal [X6], [EN1], [EN2], and [FM2] functions cannot be used.
If terminal [X6] was used with MEGA (G1), it will be necessary to reassign to other than terminal [X6].
Table 11.21-1 Screw specification, tightening torque, and recommended wire size
Common terminal
Screw specification
Recommended wire size (mm
2
)
Screw size
Tightening torque (N·m)
Control circuit terminal
M3
0.7
0.75
Fixing screws
M3
0.7
-