Fuji Electric FRENIC MEGA G2 Series - Page 818

11.22 Built-in Option Card Types and Ports in Which They Can be Installed
11-90
■ Extension format data assignment address
When the extension format is selected (if o30 = 3), the lower 4 words are for the read area, and the higher 4 words
are for the write area.
The desired function code can be selected with the function code type and number, and reading and writing are
possible for all function codes accessible with communication.
機能コード種別
ボーリング機能コードデータ
運転状態モニタ
出力周波数モニタ(モータ速度モニタ)
運転指令･Di･RESET入力
周波数設定(モータ速度設定)
機能コード番号
セレクティング機能コードデータ
WB00**
WB00**+7
INV
↓
MICREX
MICREX
↓
INV
(MSB) (LSB)
機能コード番号
W/R
機能コード種別
0
Note) ** is the T-link bus station No. set with “RSW1” and “RSW2”.
Fig. 11.22-5
Running status monitor
Output frequency monitor (motor speed monitor)
Function code type
Function code number
Boring function code data
Run command / Di / RESET input
Frequency setting (motor speed setting)
Function code type
Function code number
Selecting function code data