8.4 OST Wizard
Figure 112: OST Wizard: Add Storage Servers
Step 3: Add LSUs
1. Enter information about the LSU (see "OST Wizard: Add LSUs" on page 150).
Storage Server Select the storage server that will contain the new
LSU.
Use Available Capacity Select this option to add an LSU that uses the
available capacity on the system.
You cannot add an available capacity LSU to a
storage server that already contains an LSU. Also, if
you add an available capacity LSU to a storage
server, you cannot add additional LSUs to that same
storage server.
After you add an LSU that uses the Available
Capacity option, you cannot change the LSU to
use the Specific Capacity option. Instead, you
must delete the LSU, then add a new LSU and
choose the Specific Capacity option (see
"Deleting an LSU" on page 244).
Specify Capacity Select this option to specify the physical capacity of
the LSU, and then enter the following information.
l LSU Name - Enter the name of the LSU.
l Physical Capacity - Enter the physical capacity of
the LSU (1 to 1048576 GB).
2. Click Add.
The LSU displays in the LSUs Added table.
3. (Optional) To add additional LSUs, repeat Steps 1–2.
ETERNUS CS800 149
To Next Page
Loading...
