Fujitsu ETERNUS CS800 S6 - Page 217

10.3 VTL Configuration
If you do not create and associate a host access group with a partition, the
virtual devices are not visible from the host, and drives cannot be destinations
for move operations (see "Remote Host Access" on page 220).
CAUTION!
Moving a virtual tape cartridge might disrupt backup jobs.
To access the Media Move page, on the Media page, click the Move tab (see "Media Move
Page" on page 217).
Figure 154: Media Move Page
To move a virtual tape cartridge:
1. In the Partition drop-down box, select the partition that contains the cartridge to
move.
2. If the partition is online, click Offline to take the partition offline. To move media, the
partition must be offline.
3. In the Source Location drop-down box, select the type of location you want to move a
cartridge from (Drive, Storage Slot, I/E Slot).
4. (Optional) If you are moving a cartridge from a drive, select the Force Unload (Virtual
Tape Drives) check box to force the drive to unload the cartridge before ejecting it.
5. (Optional) To reduce the number of cartridges displayed in the table, enter a barcode
or barcode range in the Barcode Filter box and click Apply Filter.
Use a hyphen (-) to indicate a range, and use an asterisk (*) to indicate a wildcard.
Separate multiple entries with commas, and do not use spaces.
Example: Enter AAA* to display all cartridge barcodes beginning with AAA. Or enter
AAA010-AAA020 to display all barcodes in the specified range. Click the Quick Tip
icon [?] for additional examples.
ETERNUS CS800 217