10.4 OST Configuration
You must add target IP mapping information if you are performing optimized
duplication on a segmented network and replication is not configured between
the source ETERNUS CS800 and target ETERNUS CS800.
Fujitsu Technology Solutions does not recommend mapping multiple data IP
addresses to a single replication IP address. If you have mapped multiple data
IP addresses and the routing is not working, try removing the additional data IP
addresses, and map only a single data IP address.
To access the Target IP Mapping page, on the OST page, click the Target IP Mapping tab
(see "Target IP Mapping Page" on page 248).
Figure 172: Target IP Mapping Page
Tasks
Use the Target IP Mapping page to perform the following tasks:
l View information about mapped data and replication IP addresses (see "Target IP
Mapping List" on page 249).
l Map a target data IP address to a replication IP address (see "Mapping a Target IP
Address" on page 249).
l Edit the mapping for a target data IP address (see "Editing a Mapped IP Address" on
page 249).
l Delete the mapping for a target data IP address (see "Editing a Mapped IP Address" on
page 249).
ETERNUS CS800 248
To Next Page
Loading...
