10.9 System
l Enable or disable CLI access for the administrator or viewer account (see "Enabling CLI
Accounts" on page 311).
l Enable or disable GUI access for the service account (see "Enabling GUI Service
Account" on page 315).
l Enable or disable SSH access for the service account ( see "Enabling SSH/CLI Service
Account" on page 316)
Changing GUI Administrator Password
Use the GUI password when logging onto the remote management console as an
administrator (see "Accessing Remote Management" on page 122).
1. Under GUI Administrator, enter the following information:
Old Password Enter the old password.
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
l Passwords can be up to 32 characters. Alphanumeric characters and special
characters are allowed.
l Loss of this password will require Fujitsu Technology Solutions service support.
2. Click Apply.
Enabling GUI Monitor Account
Use the GUI password when logging onto the remote management console as a monitor
(see "Accessing Remote Management" on page 122).
1. Under GUI Monitor do one of the following steps:
l Select the Enable GUI Monitor Login check box to enable the GUI monitor account.
l Clear the Enable GUI Monitor Login check box to disable the GUI monitor account.
2. Enter the following information:
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
Passwords can be up to 32 characters. Alphanumeric characters and special characters
are allowed.
3. Click Apply.
Enabling CLI Accounts
The CLI accounts provide access to the ETERNUS CS800 command line interface as an
administrator or monitor.
ETERNUS CS800 311
To Next Page
Loading...
