14.3 Analyzer
Figure 295: Performance Page
To perform network analysis:
1. In the Target IP Address box, enter the IP address of the system to perform network
analysis with.
The target system must have NetServer enabled (see "Settings" on page 421).
2. Click Start.
The throughput result is displayed under Result From Last Run in MB/s.
It takes approximately 5 seconds to refresh the results.
Settings
The Settings page allows you to enable or disable NetServer on the ETERNUS CS800.
NetServer must be enabled on the target ETERNUS CS800 system to perform network
analysis with the system (see "Performance" on page 420).
To access the Settings page, on the Network Analyzer page, click the Settings tab (see
"Settings Page" on page 422).
ETERNUS CS800 421
To Next Page
Loading...
