14.3 Analyzer
Figure 296: Settings Page
To enable or disable NetServer on the target ETERNUS CS800:
1. Select Enable NetServer to enable NetServer.
Or select Disable NetServer to disable NetServer.
2. Click Apply.
You should disable NetServer on the target system when you are done analyzing
network performance.
Disk Analyzer
The Disk Analyzer page allows you to analyze disk performance by measuring disk read
and write throughput.
To access the Disk Analyzer page, on the Analyzer page, click the Disk tab (see "Disk
Analyzer Page" on page 422).
Figure 297: Disk Analyzer Page
To perform disk analysis, click Start. The throughput result is displayed under Result From
Last Run in KB/s.
ETERNUS CS800 422
To Next Page
Loading...
