Fujitsu ETERNUS DX8100 S3 - Page 183

Chapter 3 Component Status
3.24 Port Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
183
- SFP Type
When the "Type" is "10G iSCSI", the SFP type of the port is displayed. If no SFP is installed, "Unmount" is
displayed.
If the "Type" is not "10G iSCSI", the display status varies according to the screen. A "-" (hyphen) is
displayed for the CM#x CA#y port information in the [Channel Adapter Detail] screen. This item is not
displayed in the [Port Detail] screen.
• SFP+
• SFP+ Copper
• Unknown
■ Sensor Information
The real time and threshold values (Low/High) for the temperature, voltage, current, transmission
power, and received power are displayed in the Sensor Information.
When the information cannot be obtained, a "-" (hyphen) is displayed.
The target components for this information are 10G iSCSI that have SFPs from which information can be
obtained.
Refer to "Sensor Information" (page 178)
for display items.
■ Additional IP Address Information #x (x: 1 - 15)
When "Multiple VLAN" is enabled, the IP address information (up to 15 IP addresses) that is registered
in the port is displayed.
- VLAN ID
The VLAN ID of the port is displayed between 0 - 4095.
If not specified, a "-" (hyphen) is displayed.
- iSCSI IP Address
The IPv4 address of the iSCSI port is displayed.
If not specified, a "-" (hyphen) is displayed.
- iSCSI Subnet Mask
The subnet mask of the iSCSI port is displayed.
If not specified, a "-" (hyphen) is displayed.
- iSCSI Gateway
The gateway IPv4 address of the iSCSI port is displayed.
If not specified, a "-" (hyphen) is displayed.
- iSCSI IPv6 Link Local Address
The IPv6 link local address of the iSCSI port is displayed.
Note that the IPv6 address is displayed as an abbreviation.
If not specified, a "-" (hyphen) is displayed.
• IPv6 address
fe80::xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (hexadecimal, "a" - "f" are lowercase letters)
Refer to "IPv6 Address Notation" (page 253)
for details.
When the "Type" is "10G iSCSI", the temperature, voltage, current, transmission power, and received power
for the SFP in the port are displayed.
Refer to "FC port" (page 174)
for display items.