Fujitsu fi-6670 User Manual

Chapter 6 Consumables
106
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
6 Attach the Brake Roller to the scanner.
1 Put the Brake Roller by adjusting the flat section of the rotating
shaft to the guide slot of the Brake Roller Holder.
2 Close the Brake Roller Holder.
7 Close the ADF.
Press down on the center of the ADF to return it to its original position
until the ADF clicks into place.
8 Reset the brake roller counter.
Start up the Software Operation Panel, and then reset the counter.
For details, refer to "Resetting the counters" (on page 145).
Be careful, the ADF may close and pinch your
fingers.
！！！
• Do not close the ADF while the Brake Roller Cover is
kept open.
• Confirm that the Brake Roller is attached firmly. If not,
paper feed errors such as multifieeds will occur.
CAUTION

Fujitsu fi-6670 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	256
Input color depth	24 bit
Maximum scan size	279.4 x 431.8 mm
Scanner type	Sheet-fed scanner
Sensor type	CCD
Maximum duty cycle	450000 pages per month
Auto document feeder (ADF) input capacity	200 sheets
Bundled software	Adobe Acrobat Standard, Kofax VRS Professional + Bar Code, ScandAll PRO, QuickScan Pro
Power requirements	AC 100 - 240V, 50 / 60 Hz
Maximum scan area (ADF) (imperial)	11 x 17 \
Minimum scan area (Auto Document Feeder)	2 x 3 \
Power consumption (standby)	6 W
Power consumption (typical)	216 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	299.72 mm
Width	431.8 mm
Weight	17009.7 g