Fujitsu fi-6670

Chapter 3 Scan Parameters
52
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
The TWAIN scanner driver is a driver software product that
complies with the TWAIN standard. You can use this driver to
perform a scan using a TWAIN-supported scanning applica-
tion.
Usually, you first invoke a required scanner driver from the
scanning application and configure your scanning settings in
the scanner driver's setting dialog box. (Depending on the
application settings, this setting dialog box may not appear.)
In the TWAIN scanner driver, you can configure various scan
settings in the dialog box above.
For the major scan parameters, see the description below.
For details, refer to the TWAIN Scanner Driver Help.
Resolution
Specify a resolution for scanning images.
You can select a value from the predefined standard resolu-
tions in the drop-down list. If a desired value is not listed, you
can select [Custom] to specify the value (in increments of 1 dpi
from 50 to 600 dpi).
By marking the [Predefine] checkbox, you can select one of
three predefined settings, [Best], [Better], and [Normal], and
this allows you to scan documents simply and quickly.
You can also customize the values of [Best], [Better], and
[Normal] as desired in the window that appears when the [...]
button is clicked.
Scan Type
Specify the side(s) of document to scan.
The specifiable scan types are as follows:
• ADF (Front Side)
• ADF (Duplex) (fi-6670/fi-6770 only)
• ADF (Virtual Duplex) (fi-6750S only)
• Long page (Front Side)
• Long page (Duplex) (fi-6670/fi-6770 only)
• Flat Bed (flatbed type only)
• ADF (Back Side) (fi-6670/fi-6770 only)
3.1 TWAIN Scanner Driver
How to invoke a scanner driver depends on the scanning appli-
cation you use.
For details, refer to the manual or help of the application you
use.