Fujitsu fi-6670

Chapter 4 Various Documents
76
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
3 From ScandAll PRO, perform a scan.
For how to perform a scan, refer to "ScandAll PRO V2.0 User's
Guide".
⇒ When the scanning is complete, a message appears to prompt
you to load your document face up.
4 Load the document face up on the ADF Paper Chute.
For how to load documents on the ADF Paper Chute, refer to "2.1
Loading Documents on the ADF" (on page 39).
5 In response to the message shown, click the [Yes] button.
⇒ The back-side pages of the document are scanned.
6 When the scanning is complete, the scanned document
images are sorted automatically.
！！！
When scanning the back side pages, carefully load the
document so that:
• the back-side pages will be scanned in the same order
as the front-side pages.
• the front-side pages will not be scanned up-side-down.
！！！
• The ADF Virtual Duplex option is not available once
you have selected any of the following. To use the
option, clear the selected item(s) in ScandAll PRO
and/or in the scanner driver.
- the [Output color and monochrome simultaneously]
and [Automatic Color-Monochrome Detection]
checkboxes on the [File format and Name scheme]
tab of the [Profile Editor] dialog box.
- any of the checkboxes under [Job Separator Sheet
Handling] on the [Document separator] tab of the
[Profile Editor] dialog box.
- the [Multi Image Output] checkbox in the [Multi
Image] dialog box, which is opened by clicking the
[Enable Multi Image] checkbox in the [TWAIN Driver
(32)] dialog box of the TWAIN scanner driver.
- the [Split Image] and [Blank Page Skip] checkboxes
in the [Option] dialog box, which is opened by click-
ing the [Option] button in the [TWAIN Driver (32)]
dialog box of the TWAIN scanner driver.
• The scanned images are not sorted if the page count
on the front pages differs from that on the back sides.