Fujitsu fi-6670

Chapter 1 Scanner Overview
36
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
This section explains about the bundled “ScandAll PRO”
image scanning application, which is used as an example to
explain the procedures in this manual.
ScandAll PRO supports both TWAIN and ISIS drivers. By
defining scan settings as profiles, you can customize the
settings according to your preference.
When ScandAll PRO is installed, you can also install
“ScandAll PRO ScanSnap mode Add-in”. This is an add-in
application which provides a different set of driver settings as
an alternative to using ScandAll PRO. TWAIN driver is
required to use this application. Using the ScandAll PRO
ScanSnap mode Add-in enables easy scanning with a single
button.
"Chapter 4 Various Documents" (on page 61) explains how to
scan different types of documents by using examples of the
TWAIN driver started via ScandAll PRO.
For more details about ScandAll PRO, refer to “ScandAll PRO
V2.0 User’s Guide”.
For details about ScandAll PRO ScanSnap mode Add-in, refer
to the ScandAll PRO ScanSnap mode Add-in V1.0 User's
Guide.
1.7 Image Scanning Application
！！！
You cannot use ScandAll PRO ScanSnap mode Add-in in the
following cases:
• When the scanner is connected to fi-5000N
• When the scanner is connected with a SCSI cable