Fujitsu fi-6670 - [Default] Button; [Save] Button

Chapter 8 Operational Settings
142
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
[Default] button
Resets the scanner settings to the factory default.
[Save] button
Backs up the scanner settings and saves it to your computer.
(This button is useful when you want to configure the same
settings to the other fi-6770/6750S/6670 scanner.)
Scan Setting for
Document in
Dark Background
Color
(Only displayed
when the connec-
tion is via VRS
option)
Specify whether or not to detect
the edge of document in a dark
background color during scanning.
You can specify a density of
background color so the edge will
be detected correctly.
Once this option is enabled, the
settings for scanning documents
with tabs will automatically be
disabled.
Disable/Enable
Density of background color: 1 to 5
levels
Disable No Yes
Overcrop/Under-
crop
(Only displayed
when the connec-
tion is via VRS
option)
Adjust the output image scanned
by enabling the Automatic Page
Size Detection option.
Overcrop: 0 mm to 3 mm (in increments
of 1 mm)
Undercrop: -3 mm to 0 mm (in incre-
ments of 1 mm)
0 mm No Yes
Pick Pressure Specify the pick pressure for
feeding documents.
Low/Mid/High Mid Yes Yes
Overscan Control Specify whether to expand the
scannable area or not at overscan.
Normal/Expand Normal Yes No
Paper feeding
retry times
Specify how many times the
scanner retries feeding (picking)
paper.
1 to 8 times 6 times Yes Yes
Item Explanation Selectable Parameters Default Connection via
SCSI/USB
Connector
For connec-
tion via VRS
option:
Yes: Configurable
No: Not configurable
！！！
"Save" is to write the EEPROM values on the scanner to a file.
If any values are changed just before, click the [Apply] button
and then click the [Save] button.