Fujitsu fi-6670

Chapter 1 Scanner Overview
33
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
application that supports the scanner driver.
This product bundles the TWAIN driver and the ISIS driver
(compliant to the respective standards), Kofax VRS, and an
application called "ScandAll PRO" which supports both drivers
and Kofax VRS.
1 Turn the scanner ON.
For how to turn on the scanner, refer to "1.4 Turning the Scanner ON
and OFF" (on page 31).
2 Load a target document on the scanner.
For how to load documents on the scanner, refer to "Chapter 2
Loading Documents" (on page 38).
3 Launch an application you want to use for scanning.
The following steps show example windows when ScandAll PRO is
selected.
When ScandAll PRO is launched:
For how to launch ScandAll PRO, refer to "ScandAll PRO V2.0 User's
Guide".
1.6 Basic Flows of Scanning Documents
• For details about the scanner drivers, refer to the following:
- "Chapter 3 Scan Parameters" (on page 51)
- TWAIN Scanner Driver Help
- ISIS Scanner Driver Help
• For details about Kofax VRS, refer to:
- Kofax VRS Help
• For details of ScandAll PRO, refer to the following:
- ScandAll PRO V2.0 User's Guide
- ScandAll PRO Help
！！！
• For a SCSI cable connection, be sure to turn on your
computer AFTER turning on the scanner, and making
sure number "1" indicates on the Function Number
Display.
• Turn off the scanner and your computer first when you
switch the interface cable.