Chapter 4 Various Documents
89
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
Intelligent Multifeed Function
Use this function when you want to continue scanning while
checking if any sticky notes are attached to the document
each time the multifeed error occurs.
To select one of the modes above, use the Software Operation
Panel.
For details, refer to "Setting A Non-Multifeed-Detection Range
[Intelligent Multifeed Function]" (on page 164).
Settings Before Using This Function
Prior to using this function, you need to configure the following
settings:
■With TWAIN Scanner Driver
1 Start up ScandAll PRO, select the [Scan] menu D [Scan
Settings].
⇒ The [TWAIN Driver (32)] dialog box appears.
2 Click the [Option] button.
3 Select the [Job/Cache] tab, and select [Check overlap-
ping] or [Check overlapping and length] for [Multifeed
Detection] under [ADF Option].
Mode Description
Manual Mode
(Bypass by Opera-
tor Panel button)
The scanner stops scanning each time a multi-
feed error is detected. You can resume scanning
after checking for any glued paper on your
document on detection of each multifeed error.
Auto Mode 1
(Bypass by length
and position)
Used to scan a document stack with paper of the
same size glued at the same position.
Auto Mode 2
(Bypass by length)
Used to scan a document stack with paper of
different sizes glued at different positions.
Irregular (incomplete or deformed) images may be created
when multifeeds occur.
To Next Page
Loading...
