Fujitsu SPARC Enterprise M3000 Service Manual

9-4 SPARC Enterprise M3000 Server Service Manual • March 2012
9.1.3 Cold Replacement
For cold replacement, stop the domain and then power off the server. See Section
Section 4.5.1, “Powering off the Server” on page 4-12.
9.2 Removing a Hard Disk Drive
Note – If a new hard disk drive is to be installed in an empty disk slot, remove the
HDD filler panel first.
1. Push the square button on the front of the hard disk drive (1 in
FIGURE 9-2) to
release the eject/lock lever (2 in
FIGURE 9-2).
2. Pull the eject/lock lever (3 in
FIGURE 9-2) so that the hard disk drive is pulled
straight out from the unit (4 in
FIGURE 9-2).

Fujitsu SPARC Enterprise M3000 Specifications

General

Brand	Fujitsu
Model	SPARC Enterprise M3000
Category	Server
Language	English