4-1
CHAPTER
4
FRU Replacement Preparation
This chapter explains the method of preparing for the safe replacement of FRUs.
■ Section 4.1, “Tools Required for Maintenance” on page 4-1
■ Section 4.2, “FRU Replacement and Installation Methods” on page 4-2
■ Section 4.3, “Active Replacement/Active Addition” on page 4-5
■ Section 4.4, “Hot Replacement/Hot Addition” on page 4-7
■ Section 4.5, “Cold Replacement/Cold Addition” on page 4-12
4.1 Tools Required for Maintenance
The actual maintenance work described in Chapter 5 to Chapter 15 requires
maintenance software to confirm that the server and other components are operating
correctly and to collect status information and log data on the server and
components. Work for mounting, removing, or replacing a specific component
requires special tools, including screwdrivers and an antistatic wrist strap. These
items are generally named maintenance tools and are listed in
TABLE 4-1.
TABLE 4-1 Maintenance Tools
Item Part Name Use
1 Phillips screwdriver (No. 2)
2 Wrist strap For electrostatic control
3 Conductive mat For electrostatic control
4 Oracle VTS Test program
To Next Page
Loading...
Need help?
General