Fujitsu SPARC Enterprise M3000 Service Manual

5-1
CHAPTER
5
Internal Components Access
This chapter explains how to access internal components.
■ Section 5.1, “Sliding the Server Into and Out of the Equipment Rack” on page 5-1
■ Section 5.2, “Removing and Attaching the Top Cover” on page 5-3
■ Section 5.3, “Removing and Attaching the Air Duct” on page 5-4
■ Section 5.4, “Removing and Attaching the Fan Cover” on page 5-7
5.1 Sliding the Server Into and Out of the
Equipment Rack
This section explains how to slide the server out from the equipment rack and how
to push it into the equipment rack.
For details of equipment racks, see the SPARC Enterprise Equipment Rack Mounting
Guide.
5.1.1 Sliding the Server Out from the Equipment Rack
Caution – To prevent the equipment rack from tipping over, you must deploy the
antitilt feature, if applicable, before you slide the server out of the equipment rack.
Note – If cable management arms are not attached, remove the cable ties securing
the PCI cables to the rear of the server and slide the server out.

Fujitsu SPARC Enterprise M3000 Specifications

General

Brand	Fujitsu
Model	SPARC Enterprise M3000
Category	Server
Language	English