Chapter 3 Troubleshooting 3-11
3.5 Using Troubleshooting Commands
When any message listed in TABLE 3-4 is displayed, detailed information on the error
may be required. For details on troubleshooting commands, see manual pages of the
Oracle Solaris OS or XSCF Shell. This section provides detailed explanations of the
following commands:
■ “Using the showhardconf Command” on page 3-11
■ “Using the showlogs Command” on page 3-14
■ “Using the showstatus Command” on page 3-15
■ “Using the fmdump Command” on page 3-16
■ “Using the fmadm Command” on page 3-17
■ “Using the fmstat Command” on page 3-19
3.5.1 Using the showhardconf Command
The showhardconf command displays information on each FRU. The following
information is displayed:
■ Current configuration and status
■ Number of mounted units
■ Domain information
■ Name properties of the PCIe card
To Next Page
Loading...
Need help?
General