2-76 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
3. Use the showldapssl(8) command to confirm the use of LDAP/SSL server.
Specifying an LDAP/SSL Server and Port Number
■ Command operation
1. Use the showldapssl(8) command to display LDAP/SSL server settings.
2. Use the setldapssl(8) command to configure LDAP/SSL servers.
XSCF> showldapssl
usermapmode: disabled
state: enabled
strictcertmode: disabled
timeout: 4
logdetail: none
XSCF> showldapssl server
Primary Server
address: (none)
port: 0
XSCF> showldapssl server -i
Alternate Server 1
address: (none)
port: 0
Alternate Server 2
address: (none)
port: 0
Alternate Server 3
address: (none)
port: 0
Alternate Server 4
address: (none)
port: 0
Alternate Server 5
address: (none)
port: 0
<Example 1> Specify the primary server and port number.
XSCF> setldapssl server 10.18.76.230:4041
<Example 2> Specify the alternative server.
XSCF> setldapssl server -i 1 10.18.76.231
To Next Page
Loading...
