Fujitsu SPARC EnterpriseM3000 User Manual

Chapter 2 Setting Up XSCF 2-109
Permitting or Refusing the SSH Access to XSCF from Domain via
DSCP
■ Command operation
1. Use the showssh(8) command to display SSH settings.
2. Use the setssh(8) command to permit or refuse the SSH access to XSCF from
domain via DSCP.
3. To permit and refuse the SSH access, the XSCF reset is required. Use the
rebootxscf(8) command to reset the XSCF.
■ After the XSCF reset, the XSCF session is disconnected. Please log in again to the
XSCF.
XSCF> showssh
SSH status: enabled
SSH DSCP: accept
RSA key:
:
DSA key:
:
<Example 1> Permit SSH access.
XSCF> setssh -m dscp=accept
Continue? [y|n] :y
Please reset the XSCF by rebootxscf to apply the ssh settings.
<Example 2> Refuse SSH access.
XSCF> setssh -m dscp=deny
Continue? [y|n] :y
Please reset the XSCF by rebootxscf to apply the ssh settings.
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n] :y

Fujitsu SPARC EnterpriseM3000 Specifications

General

Brand	Fujitsu
Model	SPARC EnterpriseM3000
Category	Server
Language	English