Chapter 2 Setting Up XSCF 2-185
Changing the Initial Hardware Diagnostic Level
■ Command operation
1. Use the showdomainmode(8) command to display the initial hardware
diagnostic level.
Note – The -v option and the display for ethernet address is supported in XCP1082
or later.
<Example> Display the initial hardware diagnostic levels of domain
ID 0.
XSCF> showdomainmode -d 0 -v
Host-ID :0f010f10
Diagnostic Level :min
Secure Mode :off
Autoboot :on
CPU Mode :auto
Ethernet Address :00:0b:5d:e2:01:0c
To Next Page
Loading...
