2-186 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
2. Use the setdomainmode(8) command to change the initial hardware diagnostic
level.
3. Use the showdomainmode(8) command to confirm the initial hardware
diagnostic level.
Enabling or Disabling the Host Watchdog Function and the Break Signal
Suppression
â– Command operation
1. Use the showdomainmode(8) command to display the host watchdog and break
signal suppression setting.
<Example> Specify the maximum initial hardware diagnostic level for domain ID 0.
XSCF> setdomainmode -d 0 -m diag=max
Diagnostic Level :min -> max
Secure Mode :off -> -
Autoboot :on -> -
CPU Mode :auto -> -
The specified modes will be changed.
Continue? [y|n]:y
configured.
Diagnostic Level :max
Secure Mode :off (host watchdog: unavailable Break-signal:receive)
Autoboot :on (autoboot:on)
CPU Mode :auto
<Example> Display the initial hardware diagnostic levels of domain
ID 0.
XSCF> showdomainmode -d 0
Host-ID :0f010f10
Diagnostic Level :max
Secure Mode :off
Autoboot :on
CPU Mode :auto
<Example> Display the setting for domain ID 0.
XSCF> showdomainmode -d 0
Host-ID :0f010f10
Diagnostic Level :max
Secure Mode :off
Autoboot :on
CPU Mode :auto
To Next Page
Loading...
Need help?
General