Fujitsu SPARC EnterpriseM3000 User Manual

Chapter 2 Setting Up XSCF 2-187
2. Use the setdomainmode(8) command to specify host watchdog and break
signal suppression.
3. Use the showdomainmode(8) command to confirm the secure mode is on. Also,
to apply the setting to the domain, restart the domain.
Enabling or Disabling the Automatic Boot Function
■ Command operation
1. Use the showdomainmode(8) command to specify automatic boot.
<Example> Enable Host watchdog and Break signal suppression for domain ID 0.
XSCF> setdomainmode -d 0 -m secure=on
Diagnostic Level :max -> -
Secure Mode :off -> on
Autoboot :on -> -
CPU Mode :auto -> -
The specified modes will be changed.
Continue? [y|n]:y
configured.
Diagnostic Level :max
Secure Mode :on (host watchdog: available Break-signal:non-receive)
Autoboot :on (autoboot:on)
CPU Mode :auto
XSCF> showdomainmode -d 0
Host-ID :0f010f10
Diagnostic Level :max
Secure Mode :on
Autoboot :on
CPU Mode :auto

Fujitsu SPARC EnterpriseM3000 Specifications

General

Brand	Fujitsu
Model	SPARC EnterpriseM3000
Category	Server
Language	English